
Target limits for qualification batches. Measured values for each delivery are reported on the batch Certificate of Analysis, which takes precedence over this page. Sintering behaviour, densification and optical properties depend on the host system, forming method and firing schedule and are not specified here.
| Tier | Container |
|---|---|
| 100 g | HDPE container |
| 1 kg | HDPE container |
| 5 kg | HDPE container |
| 25 kg | Fibre drum with PE liner |
Limits on this page are the design targets of the development programme. Each delivery ships with a Certificate of Analysis carrying the measured values.
Sample quantities for evaluation: 100 g to 1 kg. Where a published grade does not fit the requirement, a paid evaluation puts your specification through the same measurement stack.
Request a paid evaluationAgglomerate D50 0.5 to 1.5 µm, primary crystallites 0.1 to 0.25 µm, D90 ≤ 5 µm, specific surface area 5 to 15 m²/g by BET. Soft agglomerates break down further under slurry milling, and the powder distributes evenly in ceramic batches at low addition levels.
Cubic Y₂O₃ (bixbyite) with no secondary phase detected by XRD. Surface area can be adjusted on request between approximately 3 and 25 m²/g for sintering-aid versus synthesis use.
≥ 99.99% Y₂O₃ on a total oxide basis, Y₂O₃/TREO ≥ 99.995%, ≤ 100 ppm total impurities. Limits are published element by element and reported on every batch.
Quantities are quoted directly and formulation runs through engineering.