World Space Week / / / 4-10 Oct →
Strocera

Sintering aid for Si₃N₄, AlN and SiAlON.

Sintering aid and grain-boundary phase former for Si₃N₄, AlN and SiAlON structural and substrate ceramics.

STROCERA / / / High-Purity Yttrium Oxide / / / Industrial
[ 01 ]The challenge

A sintering aid is added at low levels, but it controls the grain-boundary phase of the finished ceramic. To do that, it has to distribute evenly through the batch. A coarse or hard-agglomerated additive leaves local concentrations, and impurities carried in with it end up at the grain boundaries.

Schematic, illustrativeHigh-Purity Yttrium Oxide
[ 02 ]The Strocera approach

YOX-40 is supplied as fine, soft-agglomerated powder that disperses readily in aqueous and organic slurries and distributes evenly in ceramic batches at low addition levels. Agglomerate D50 is 0.5 to 1.5 µm, D90 ≤ 5 µm, and hard agglomerates above 20 µm are limited to ≤ 0.5% by volume. Surface area can be adjusted on request between approximately 3 and 25 m²/g.

Full High-Purity Yttrium Oxide spec
[ 03 ]Specifications for this use case
Property
Value
Method
Purity, Y₂O₃, total oxide basis
≥ 99.99% (4N), ≤ 100 ppm total impurities
ICP-MS / ICP-OES
D50, median (agglomerate)
0.5 to 1.5 µm
ISO 13320, wet
D90
≤ 5 µm
ISO 13320, wet
Oversize, > 20 µm
≤ 0.5% by volume (hard agglomerates)
Laser diffraction
Specific surface area, BET
5 to 15 m²/g
ISO 9277
[ 04 ]Validation status
Pending

Target specification issued for product qualification. Results depend on the host system, forming method and firing schedule.

[ 05 ]Customer profile

Silicon nitride, aluminium nitride and SiAlON producers selecting a yttria sintering additive.

[ 06 ]Adjacent use cases

Engineers working on this often also evaluate:

Bring your specification for Sintering aid for Si₃N₄, AlN and SiAlON.

Tell us the operating conditions. We'll formulate High-Purity Yttrium Oxide to your application, and ship powder matched to your firing schedule.