World Space Week / / / 4-10 Oct →
Strocera

Chamber hardware refurbishment and recoating.

Spray feedstock for refurbishing and recoating in-service chamber hardware.

STROCERA / / / Yttria Thermal Spray Powder / / / Semiconductor Equipment
[ 01 ]The challenge

Chamber parts return for recoating many times over their service life. A refurbishment line has to reproduce the same coating on every cycle, and a change in feedstock behaviour between lots forces the process to be adjusted while hardware waits to go back into service.

Schematic, illustrativeYttria Thermal Spray Powder
[ 02 ]The Strocera approach

YSP-40 is specified for the variables a recoating line watches: D50 15 to 25 µm, D90 ≤ 45 µm, Hall flow ≤ 60 s / 50 g, apparent density 1.4 to 2.0 g/cm³ and hollow or fractured granules ≤ 10% by number. Measured values are reported on the Certificate of Analysis of each batch, so a new lot can be checked against the last one before it reaches the torch. Sample quantities for qualification are 1 to 5 kg per cut.

Full Yttria Thermal Spray Powder spec
[ 03 ]Specifications for this use case
Property
Value
Method
Purity, Y₂O₃, total oxide basis
≥ 99.99% (4N), ≤ 100 ppm total impurities
ICP-MS / ICP-OES
D50, median
15 to 25 µm
ISO 13320
Hall flow rate
≤ 60 s / 50 g
ASTM B213
Apparent density
1.4 to 2.0 g/cm³
ASTM B212
Hollow / fractured granules
≤ 10% by number
SEM, cross-section
[ 04 ]Validation status
Pending

Target specification for qualification batches. Reference APS data will follow with the first qualified batches.

[ 05 ]Customer profile

Refurbishment and recoating service providers working on in-service chamber hardware.

[ 06 ]Adjacent use cases

Engineers working on this often also evaluate:

Bring your specification for Chamber hardware refurbishment and recoating.

Tell us the operating conditions. We'll formulate Yttria Thermal Spray Powder to your application, and ship spray feedstock matched to your process.